Why won't my burners light on my Goodman furnace? - how to clean a goodman furnace
I have a Goodman furnace to 2002 with an autopilot.
The role is easy, but my burner does not light. I had changed the gas valve and pressure switch and clean the flame sensor with sandpaper. Can anyone tell me what is the problem?
Sunday, February 7, 2010
How To Clean A Goodman Furnace Why Won't My Burners Light On My Goodman Furnace?
Subscribe to:
Post Comments (Atom)
6 comments:
I learned the hard way that when light bar still be bad. I have a millivolt for the system to understand its operation determined. In general, to replace about $ 2x.00 and resolved in my case my problem. Of course, turn off the power before starting. Do not touch the brilliance of igniter with bare hands, with a clean cloth or gloves tissue oil from your hand to prevent the lighter too. The same problem can with an oven, which has an ignition occur, the second time that I knew what the problem was. Good luck.
It is likely that the PCB. It is a small relay (switch) on the route that lights up the gas valve after preheating coil (the).
Unfortunately for you, Janitrol and Goodman are probably the cheapest of the ovens on the market. I am replacing an entrepreneur and heating circuit Goodman, more than any other brand.
I replaced a circuit board in a Goodman furnace with this particular issue only 2 weeks. The selling price of this tour will run between $ 150 to $ 200
Yes, ok, finally, the gas valve or a pressure switch? Check ventilation if his demand for a technology course.
Side note ........ Sand is sometimes material for the sensor driver badly want you to be replaced by May conductor Witha new sensor before calling a technician.
The problem most likely is the flame sensor. If things continue on the heated believe there is no flame and does not work.
i coil is to try a spark to generate hit with another piece of metal or light hand with a lighter or match, too.
Your system should try things to light. When the candle is lit, you hear the gas valve to open? You will hear when it is usually within 90 seconds of the candle. It is possible that the order to open the gas valve and not only because everything that is good, according to orders, the system does not prove that all is well. and is safe, easy to control the glow plugs and the gas valve and flame detector. If the lights on the system, then the flame goes out the sensor. If there is a problem that does not exhaust test the system was not safe for gas does not need to go. I have systems like I'm a bit lost and lose their workflow views. It starts with one and go to Z, and if there is anyone who is out of sequence will not work. Normally, you get a code, and you can see which part failed. Check the valve though. It is becoming apparent to control the light, not only what the Council does not see the problem. When the stove white locks, there is a problemremove and eat a single code minutes and go through the sequence of operation and can be verified. You are not locked when you see the candle. I hope I was some help.
Post a Comment